Qlogic SANbox 5600 Series, Installation Manual

Page: 101 / 280

5 – Diagnostics/Troubleshooting
Power-On Self Test Diagnostics
59096-02 C 5-5
A
1. Place the switch in maintenance mode. Press and hold the Maintenance
button. When the Heartbeat LED alone is illuminated, release the button.
Refer to
”Recovering a Switch” on page 5-12 for more information about
maintenance mode.
2. Establish a Telnet session using the default IP address 10.0.0.1.
telnet 10.0.0.1
3. Enter the account name (prom) and password (prom), and press the Enter
key.
Switch login: prom
Password:xxxx
4. The following menu is displayed. Enter "6" (Remake Filesystem) and press
the Enter key to recreate the configuration file.
0) Exit
1) Image Unpack
2) Reset Network Config
3) Reset User Accounts to Default
4) Copy Log Files
5) Remove Switch Config
6) Remake Filesystem
7) Reset Switch
8) Update Boot Loader
Option: 6
5. When the recreate process is complete, select option 7 to reset the switch
and exit maintenance mode.
6. If a previously saved configuration file is available for the switch, do the
following to restore the configuration file.
a.
Establish communications with the switch using the File Transfer
Protocol (FTP). Enter the following on the command line:
>ftp 10.0.0.1
b. Enter the following account name and password:
user:images
password:images
c. Activate binary mode and copy the configuration file from the
workstation to the switch. The configuration file must be named
"configdata".
ftp>bin
ftp>put configdata
d. Close the FTP session.
ftp>quit