Qlogic 3000 Series, Reference Manual

Page: 46 / 98

2–Fabric Discovery Classes
QLGC_FCPort : CIM_FCPort
2-8 59223-03 E
Parameters:

RequestedState: [required] A port specific array of valid values
may be found in the
FCPortCapabilities.RequestedStatesSupported property.
Parameter must be one of the following enumerated values.

2-Enabled: Port is online.

3-Disabled: Port is offline

7-Test: Port is in diagnostics mode.

11-Reset: Port will be reset.

Job: Ignored, command is synchronous.

TimeoutPeriod, must be zero second interval, or NULL,
command is synchronous.
Method Returns:

0 - Success

1 - Not Supported: (NS/Remote Ports) Method applies to local
ports only.

6 - In Use: Switch is being configured by another user;

4097 - Invalid State Transition: RequestedState parameter
value is out of range.

4098 – Use of Timeout Parameter Not Supported
Request Status Codes:

CIM_ERR_ACCESS_DENIED: User does not have
authorization for this command.

CIM_ERR_INVALID_PARAMETER: One or more required
parameters are missing.

CIM_ERR_NOT_FOUND: The FCPort instance was not found.
QLogic Extended Properties and Methods
HealthState
(Local Only)
This property will report the diagnostic status of the port as a result of
the Switch POST. Supported values are:
0 – Unknown Port is not installed
5 – OK No errors
25 – Critical Failure Port failed POST