22
5888UV
7
General Setting
Press the Main band selector knob or
51
key to store value and
back to function menu. Press
key or hold selector knob for over
0.5 second to store setup and exit.
Short press:
In VFO mode, short press this key, the
frequency step size changes to 1Mhz,in channel mode,
adjust selector knob will jump 10 channels.
long press:
In standby, long press this key to ad/delete
optional signaling, repeat the long press it, will set optional
signaling DTMF,5TONE or 2TONE. When the LCD displays
After the above setup, hold microphone PTT key and [ DOWN ]
key, the
radio will transmit selected tone.
Press
11
key to enter function menu.
Turn the Main band selector knob to
21
choose No 20 menu. The LCD displays
"
KEYMOd
"
Press the Main band selector knob to enter function setup.
31
Switch the Main band selector knob to choose wanted mode.
41
KEY1:
key1 mode, Normal mode, the left
4 keys have same functions as the
right 4 keys.
KYE2:
the left 4 keypads will shared by both band. And the right 4
key pads will re-defined.
Press the Main band selector knob or
51
key to store value and
back to function menu. Press
key or hold selector knob for over
0.5 second to store setup and exit.
keYpAd Mode Setup
DT means DTMF, displays 5T means 5TONE, displays 2T
means 2TONE. In VFO mode, long press this key, the step
size change to 10Mhz.
short press:
Frequency reverse function, when current
channel is setup with offset direction and offset frequency,
press this key will turn on frequency reverse function. When
frequency reverse function the TX frequency turns to RX
frequency & RX frequency changes to TX frequency. The
signaling will also be reversed if CTCSS/DCS signaling
existed in this channel. Repeat shot press it will turn off
Frequency reverse function.
long press:
In stand by, hold this key until the LCD
displays
, means the compander function is on, repeater
above operation to turn off compander function.
short press:
In standby, press this key to set the
CTCSS/DCS code for current channel.
When the LCD displays ENC, the current channel is with
CTCSS encode function.
When the LCD displays ENC and DEC, the current channel
is with CTCSS /DCS code function.
When the LCD displays DCS and DCS icon, the current
channel is with CTCSS code function.
When the LCD displays OFF, the current channel is without
CTCSS /DCS function.
long press:
In standby, long press this key to enter
CTCSS/DCS scan, when find matching CTCSS/DCS signal,
the scan will pause in the way fllowing Scan Dwell time.
The scan direction can be changed by corresponding
channel selector knob.
Note:To enable this function, the channel shall be
programmed with CTCSS/DCS decode.
7
NOTE
Notice:
Definition of 4 Right band Keypad in KEY2 mode:
31
41
51
61
11
21
Summary of Contents for T4K-5888UV
Page 45: ...A1 0 12 11...
