- 11 -
raise the enrichment lever to the
highest position. After starting,
lower the lever to a half way and
allow the engine to warm up to a
proper
temperature,
before
returning the enrichment lever to
its home position.
②
Wire type
enrichment plunger carburetor:
To start a cold engine, put the wire
handle forward to the end position.
After starting, put the handle to a
middle position and allow the
engine to warm up to a proper
temperature, before returning the
enrichment handle back to its
home position.
Note
:
The enrichment system is
designed for starting a cold engine.
When temperature is low, the
warming time shall be extended
properly (if no warming is made,
the speed transition may become
poor).
During
driving,
the
enrichment system shall be shutoff;
otherwise the fuel consumption
may be increased. The correct
enrichment shutoff status is
:
For
vacuum carburetor, fully push in
the lever
;
For plunger carburetor,
lower the lever to the end
;
For
wire type enrichment carburetor,
turn it to the front end.
Warning
:
After using the enrichment
system, shutoff it timely to prevent
overheat that may damage the
silencer elbow.
Kickback start lever
The kickback start lever is
installed on the right side of the
motor.
Owing
to
motorial
kickback starting mechanism, the
engine can be started in any gear
position provided the clutch is
released.
Warning
:
After the engine is started,
check if the start lever has
returned to its normal position.
Do not use the kick starter and
electric starter at the same time.
Helmet lock