QIAamplifier 96 User Manual 03/2020
14
observed. The following general notes do not replace the specific local regulations or the regulations
in the EC safety data sheets of the manufacturers for the auxiliary and operating materials.
Observe the following:
Protective goggles and rubber gloves have to be worn when handing reagents.
If only a few samples are treated, an (empty) tube of the same height must additionally be
placed at each corner position of the block. If the number of samples in the block is too low,
there is a risk of the tubes being damaged and sample liquid leaking out.
For your own safety, observe the potential infectious qualities of the examined biological
material.
2.6.5
Safety instructions – service and repair
The QIAamplifier 96 is usually repaired by the service department of QIAGEN or its authorized
and trained specialist personnel. Unauthorized repairs can damage the device. Therefore, the
operator may generally only carry out the tasks listed in chapter Maintenance and care.
The following must be observed:
The exterior of the device may only be cleaned with a damp, not dripping, cloth after the
device has been switched off.
Do not use alcohol (e.g., methanol or ethanol), organic solvents, or abrasives to clean the
device.
Any maintenance on the device may usually only be carried out in the switched-off condition
(unless stated otherwise).
2.7
Behavior during emergencies
In case of danger or accidents, immediately switch off the QIAamplifier 96 using the main switch
on the equipment backplate. Disconnect the mains plug from the power supply.
