EZ1 Advanced XL User Manual 11/2017
37
4.3.4
Installing the printer
Printers sold in the open market can be connected to the instrument.
Unpack the printer. Follow the supplier’s instructions for use to carry out the following steps.
1.
Insert the fabric ribbon.
2.
Insert the paper roll.
3.
Connect the printer’s data cable.
4.
Connect the printer to an appropriate AC power outlet via the power cord.
5.
Switch on the printer.
6.
Use the appropriate power cord, included with the printer. Use the data cable included with
the printer, with a 9-pin connector on one end and a 25-pin connector on the other end.
7.
Connect the printer’s data cable to the EZ1 Advanced XL. The connector is located at the rear
of the instrument, labeled “PC/Printer” (Section 3.1.5, page 22). Make sure that the
connector is secured with the 2 screws provided.
8.
Check that the printer is correctly connected and working properly (Section 5.9.3, page 65).
4.3.5
Installing the bar code reader
The bar code reader is powered through the data cable. Unpack the bar code reader. Connect the
cable to the bar code reader.
Connect the bar code data cable to the EZ1 Advanced XL. The connector is located at the rear of
the instrument, labeled “Barcode Reader” (Section 3.1.5, page 22). Make sure that the connector
is secured with the 2 screws provided. Switch on the EZ1 Advanced XL.
