14
– 12|2019 – Subject to change.
Kidgoo 2020
Inserting the wheels
»
Remove the black rubber caps from the ends of the thru-axles and then dispose of them.
»
Lift the cabin a little bit or place the cabin on its roof in order to install the wheel easier.
»
Insert one wheel into the cabin’s axle retainer:
–
Hold the wheel so that you can press your
thumb onto the rubber cap on the outside of
the wheel hub.
–
Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will
go into the axle retainer.
–
Release the rubber cap to secure the push-in
axle.
»
Pull on the wheel to check that the wheel is locked in
the axle retainer.
»
Insert the second wheel in the same way.
»
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 3 bar).
If necessary, use an air pump for car valves to top up with air.
Installing the wheel guard and the leaf spring cover
The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars or
similar obstacles. The leaf spring covers serve as protection against bruises.
»
Make sure that the slide rails for the wheel guard
and leaf spring cover are fixed and tightened on
both sides.
»
Slide the wheel guard onto the slide rails as shown
in the picture.
»
Be sure that the fixing mechanism locks audibly.
»
Repeat the procedure on the other side of the
trailer.
»
Slide the leaf spring cover onto the slide rail as
shown in the picture.
»
Be sure that the fixing mechanism locks audibly.
»
Repeat the procedure on the other side of the
trailer.
Assembly
Installing the disc brake (Kidgoo Sport)
Follow the instructions in the manual of the Disc Brake Addon.
