18
– 12|2019 – Subject to change.
Kidgoo 2020
Assembly
Caution!
Secure the bicycle to prevent it from toppling over, and make sure that the rear
wheel cannot drop out of the axle mount after the screw connection has been
undone. Use for example an assembly stand, or turn the bicycle upside down so
that you can place it on its saddle and handlebars.
Danger!
Make sure that your bicycle is suitable for towing a bicycle trailer, see
„Performance limits“ on page 4
. Since it may in some cases be necessary to
change the rear wheel axle, it is best to consult your specialist dealer or the bicycle
manufacturer in order to do this.
Tip!
You do not have to remove the tow bar completely. Simply place the tow bar into
the tow bar mount from behind to stow it under the cabin floor, see
„Insert tow
bar“ on page 22
.
Mounting the coupler onto a bicycle
»
Prepare the bicycle for mounting the coupler by undoing the screw connection of the rear
wheel axle:
–
Quick-release axle: Open the bracket of the quick-release axle and unscrew the cap nut
on the other side of the rear wheel axle.
–
Full axle: Unscrew the nut on the left side of the rear wheel axle.
»
Mount the coupler on the rear wheel axle:
–
Place the large hole of the coupler onto the left side of the rear wheel axle so that the
coupler is facing outwards.
–
Screw on the dedicated nut and tighten it slightly.
–
Align the rear wheel so that it can turn freely.
–
Align the coupler so that it faces horizontally to the rear.
»
Tighten the connection to secure the rear wheel:
–
Quick-release axle: Use the supplied quick
release adapter. Tighten the cap nut until you
can close the clamp with a certain amount of
pressure.
–
Full axle: Tighten the nut with a spanner.
Always pay attention to the bicycle
manufacturer’s notes about the tightening
torque.
