Kidgoo 2020
Subject to change. – 12|2019 –
15
Assembly
Installing the head protectors
The head protectors serve as additional side protection in case the trailer should tip over.
»
Be sure that the slide rails for the head protectors
are fixed and tightened on both sides.
»
Slide the head protector onto the slide rail as
shown in the picture.
»
Be sure that the fixing mechanism locks audibly.
»
Repeat the procedure on the other side of the
trailer.
Mounting the push handle
The push handle has multiple height settings and is used for pushing, pulling and manoeuvring your
Kidgoo
. When folded, the push handle also provides roll over protection.
»
Prepare the push handle by fully unfolding it. To do
this, press and hold the push buttons on both sides,
see Adjusting the push handle on page 20.
»
Open the two quick-release fasteners on the cabin
frame.
»
Insert the bolts of the push handle into the socket
on the cabin frame.
»
Close the quick-release fasteners.
Caution!
When mounting the push handle, make sure that the round joint with the push
buttons point upwards (see picture). Only then can the push handle be adjusted to
all positions.
Danger!
Make sure that the push handle is also mounted in trailer mode each time you
drive as shown in the table (see
„Setting the mode“ on page 21
), only
then is the cabin equipped with an additional roll bar.
