QED BIOGAS 5000, Operating Manual

Page: 26 / 108

5K-MNL-BIOGAS5000
BIOGAS 5000 gas analyzer
Page
26
charger plug. Temperature can dramatically affect the battery life; please take this into
account when estimating battery life. The unit should be switched-off while charging to give a
complete and consistent charge. Turning off Bluetooth and dimming the contrast will increase
battery life.
6.10 Cleaning instructions
Do NOT use any cleaning agents to clean the analyzer or battery charger as they may have
an adverse effect on the safe use of these devices. The analyzer can be wiped off with a damp
cloth.
6.11 Memory
The analyzer's memory is stored in sections for readings and configuration information.
 Note: The analyzer should never be stored for prolonged periods with valuable data in its
memory. It is advisable to download all readings at the end of each day’s
monitoring. To clear the memory, please refer to the section covering LANDTEC
System Gas Analyzer Manager (LSGAM).
6.12 Warning and error codes
Upon the initial startup of the analyzer a self-test is performed. If any notable warnings or errors exist they
will be displayed. BEFORE using the instrument with warnings or errors it is advised that you should
contact Technical Support at +1 (
734
)
995
-
2547
or email
service
@
qedenv
.com.
When switched on the instrument will perform a predetermined self-test sequence taking
approximately ten seconds. During this time many of the instrument’s working parameters and
settings are checked. If any operational parameters are out of specification or if the pre-
programmed recommended calibration/service date has passed, errors and/or warnings may
be displayed.

Note: For further information please refer to section “ Error! Reference source not
found. Error! Reference source not found. ”.