QDI PlatiniX 8 Series, Manual

Page: 41 / 73

33
Manual for PlatiniX 8 series
Chapter 3
l
Suspend Type Stop Grant Select the Suspend type.
PwrOn Suspend
l
MODEM Use 3,4,5,7,9, Special Wake-up event for Modem.
IRQ 10,11
NA This function is not applied.
l
Suspend Mode Disabled The system never enter Suspend mode by timer.
1Min ~ 1Hour Define the continuous idle time before the system
enters Suspend mode. If any items defined in
“PM Events” are on and activated, the system will
be woken up.
l
HDD Power Disabled HDD’s motor will not be off by timer.
Down 1 - 15 Min Define the continuous HDD idle time before the
HDD enters power saving mode (motor off).
l
Soft-Off by Instant-Off The system will immediately power off once the
PWR-BTTN power button is pressed.
Delay 4 sec The system will power off when power button is
pressed for 4 seconds.
l
CPU THRM- 12.5%, 25%, Select the duty cycle of the STPCLK# signal,
Throttling 50%, 37.5%, slowing down the CPU speed when the system
62.5%, 75%, enters green mode.
87.5%
l
Wake-Up by PCI Enabled Allow the system to be waked up by PCI card.
card Disabled Do not allow the system to be powered on by
PCI card.
l
Power on by Enabled Allow the system to be powered on when a
Ring/LAN Ring indicator signal comes up to UART1 or
UART2 from external modem (to LAN Wake-up
Header from LAN adapter or to modem Ring on
Header from internal modem card).
Disabled Do not allow Ring/LAN wake up.
l
Wake -Up From Enabled The system could be waked up by USB devices
S3 by USB from the Suspend to RAM status.
Disabled The system cannot be waked up by USB devices
from the Suspend To RAM status.
l
Resume Enabled RTC alarm can be used to generate a wake-up
by Alarm event to power up the system.
30Disabled RTC has no alarm function.
P8en.p65 02-4-30, 16:28 33