QDI PlatiniX 8 Series, Manual

Page: 15 / 73

7
Manual for PlatiniX 8 series
Chapter 2
Hard Disk LED Connector (HD_LED)
The connector connects to the case’s IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn’t work, try the other way.
Reset Switch (RESET)
The connector connects to the case’s reset switch. Press the switch once, the system
resets.
ATX12V Power Supply Connector & Power Switch (POWER SW)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER SW) should be connected to a momentary switch. When powering
up your system, first turn on the mechanical switch of the power supply (if one is provided),
then push once the power switch. When powering off the system, you needn’t turn off the
mechanical switch, just Push once
*
the power switch. PlatiniX 8 series mainboard only
support ATX12V power.
POWER SW
Note
Note
If you change “Soft-off by PWR-BTTN” from default “Instant-
off” to “Delay 4 Sec” in the “POWER MANAGEMENT SETUP”
section of the BIOS, the power switch should be pressed for
morethan 4 seconds before the system powers down.
12V
12V
GND
GND
+12V
Power Supply Connector
1
ATX Power Supply Connector
20
1
5V 5 V -5V GND GND PS-ON
-12V 3.3V
GND
12V 5VSB 5V GND
3.3V
GND
5V
GND PS-OK
3.3V
GND
P8en.p65 02-4-30, 16:28 7