Manual for Advance 5/133E
Fan Connector (CPUFAN, CHSFAN)
These two fans are controllable. They will be automatically turned off after the system
enters suspend mode. You also can choose not to turn the CPUFAN off by setting “ CPU FAN
In Suspend” as On in the “POWER MANAGEMENT SETUP” section of the BIOS.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set “ Wake Up On LAN” as Enabled in the “POWER MANAGEMENT SETUP”
section of the BIOS. Save & exit, then boot the operating system once to make sure this
function takes effect.
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the power-off
status can be powered on by a ring signal received from the internal modem. If this function
is to be used, be sure an internal modem card which supports the function is used. Then
connect this header to the relevant connector on the modem card, set “ Modem Ring
Resume” as Enabled in the “POWER MANAGEMENT SETUP” section of the BIOS. Save &
exit, then boot the operating system once to make sure this function takes effect.
Installation Instruction
22
1
+5V standby
GND
Signal for waking up (active high)
1
+5V standby
GND
Signal for waking up (active low)
FAN GND(Controllable)
+12V
SENSE
CPUFAN
FAN GND
CHSFAN
+12V
SENSE
