QALCOMET HEAT 1, User Manual

Page: 35 / 52

Heat meter calculator QALCOMET HEAT 1 PEQMH1V01
35
RL
–
printing current parameter values;
- time interval
H
–
printing hourly average parameter values,
D
–
printing daily average parameter values,
M
–
printing monthly average parameter values;
- heating system number
1
–
printing report for 1-st heating system,
2
–
printing report for 2-nd heating system.
Holding down button

will allow to select report starting date and time. LCD displays:
Starting date and time should be defined. First character starts blinking. Press button

to move to
another character (selected character starts blinking). Required value can be set by shortly pressing button

. For hourly report starting hour, day and month should be defined. For daily report
–
starting day and
month, for monthly report
–
only starting month should be defined.
Holding down button

stores the selection, and report ending date selection mode will be
activated. LCD displays:
Report ending date and time is defined in the same way as describe above.
Printing will start after holding down button

one more time. While report is being printed,
blinking label “Print” will be displayed. Printing can be paused and started again (for example, to add
paper) by shortly pressing button

. If printing is paused, label “Print” will stop blinking.
Press and hold button

to move to another -
“INF” –
menu level.
Report examples are provided in Appendix H:
Error codes provided in printed report are the same as used in archive (Table 8).
Press and hold button

to stop printing in any time.
8.6. Displaying configuration settings and programming relay output parameters
Use configuration data inspection mode
“INF”
to view device configuration settings
(programmed parameters and operation modes) and
–
if regulation function is activated
–
to change relay
output parameter values.
All parameters listed in Appendix A, Table A1, are displayed in sequence as shown in Fig. 7.1.
Shortly pressing button

move to the next parameter, and button

- move to the previous parameter.
Display sequence may vary depending on selected measurement scheme, number of active sensors and
operation mode.
8.6.1. Programming relay output parameters in regulation mode
Configuration
parameters with codes “21:” ..”25:” (Appendix A, Table A1) are dedicated for
programming relay output parameters. When information data inspection mode
“INF ” is entered, it is
possible to activate or deactivate regulation function, also to choose regulated parameter and control relay
output manually by shortly pressing buttons

or

and selecting the parameter “21:”.
When button

is pressed for long time, regulation status symbol “On” or “Off” starts blinking.
Shortly pressing button

will activate (“On”) or deactivate (“Off”) regulation function.
Shortly pressing
button

will activate regulated parameter selection mode (parameter will start blinking). Select regulated
parameter code (see Appendix A, Table A1) by shortly pressing button

.
If regulation mode is deactivated (“Off”), it is possible to control the regulated valve manually.
Shortly press button

-
symbol “R” starts
blinking. Pressing button

will start closing the valve
–
symbol “vR” will be displayed. Pressing button

one more time will start opening the valve
–
symbol
“^R” will be displayed. Pressing button

once again will switch off valve control
–
only symbol
“R”
will be displayed.