QALCOMET HEAT 1, User Manual

Page: 27 / 52

Heat meter calculator QALCOMET HEAT 1 PEQMH1V01
27
Selection of measured and indicated parameters is performed using two control buttons

and

(Fig. 8.1). Configuration is modified with control buttons

and

, and parameterization button “SET”
(under the cover, see Fig. 8.2, pos.3).
Five display levels in normal mode are available: current value of integral parameters (“INT”),
instantaneous parameters (“PAR”), archive data and set day values (“LOG”), printing reports (“PRN”)
and viewing configuration data (“INF”).
Press and hold (

3 s) button to move to the next display level, and button to return to the
previous level.
Fig. 8.3 Selecting the display level.
Arbitrary symbols, used in the diagrams:
To view data in the same display level press shortly (

3 s) buttons or . The display will
switch automatically to the highest level of displaying current values of integral parameters, or
–
if at
least one error has been detected
–
error code will be displayed after 5 minutes of inactivity.
Sequence of displayed parameters may vary depending on selected measurement scheme and
number of installed sensors. The displayed parameters listing order can vary or some parameters
aren’t displayed depending on regional user requirements.
8.2. Displaying integral parameter values (level 1)
It is possible to display the following integral measured values in 1
st
display level “INT”:
E1+E2, E1, E2, E3, M1(V1), M2(V2), -M2, (M1-M2), M3(V3), M4(V4),(M3-M4),
operation time,
measurement errors.
To move to another parameter value in the same display level, shortly press buttons:

- next
parameter,

- previous parameter (Fig. 8.4).
Sequence of displayed parameters may vary depending on selected measurement scheme and
number of sensors installed.
To return to the instantaneous parameters level, press and hold button

.
PAR
LOG
PRN
INF
INT
 
   
 

 
Fig.8.1 Front of the calculator, cover closed, without seals Fig. 8.2 The cover is open
Control buttons

and

3-Configuration button
„
SET
”
1-Manufacturer
’s
warranty seal
4-Test frequency
“8192 Hz”
2-Manufacturer
’s security
seal

- left button,

- right button, - long press (

3 s) - short press(

3 s)