12
M
ic
C
ommander
Mic Gain
:
Can be adjusted from -10 dB to +30 dB. The MicCommander displays this information in present.
Name
:
Name is a 15-cha
racter alphanumeric name which can be entered for each transmitter. Note that the receiver will
not display all 15 characters of the full transmitter name.
Group
:
Group is the g
roup number (1-16) to which the transmitter belongs, allowing it to be controlled with group
commands (see Group Commands below). To change the group to which the transmitter belongs, select the
displayed group number and adjust it using the UP/DOWN arrows. Once satisfied, press the “ENTER” or “BACK”
button and “Save” when prompted.
RF Power
:
The TX output power can be adjusted from 10 mw, 25 mw, 50 mw and 100 mw. It is suggested to use the 50 mw
setting to maximize battery run time. (Selectable power values may vary by region.)
2.4 GHz Channel
:
The RCAS control chann
el default is 25, change this on the transmitter only if you are having control issues that
can be seen when you have completed a 2.4GHz spectrum scan. See Device Configuration, the 2.4 GHz Channel
description in Link ID section 3.5.
Storage Mode
:
Storage Mode will disable all communication between the MicCommander and the transmitter. To return to
standby mode, the On/Off button needs to be pressed for 3 seconds or the transmitter needs to be connected to
a charger.