27
Quick Start Guide Mic
C
ommander
This Quick Start Guide is an overview. Users are asked to review
the entire manual for detailed instructions
Included Hardware
:
•
Handheld MicCommander remote control (QG-H2)
•
Antenna
Users also need
:
•
Q5X transmitter
•
Microphone with special Lemo connector
•
2 AA batteries
Visit
to
:
•
Update the firmware
•
Register the warranty
•
Download the manuals
Prepare the handheld MicCommander remote control
:
•
Remove the rubber cover to access the battery chamber.
•
Install 2 AA batteries. Lithium ion is recommended for
best performance. Alkaline or Ni-MH are acceptable when
battery type is changed in the device configuration menu.
•
Replace the rubber cover and install the antenna on the top.
•
NEVER power the unit without the antenna in place.
•
Turn on the unit by pressing the power button on the top or
by plugging the USB cable.
•
The MicCommander will automatically shut off after two
minutes.
Prepare the transmitter (QT-5100)
:
•
Bring the transmitter out of storage mode (minimal battery
draw) and into standby mode (detectable but the UHF radio
is off) using either method below:
•
Hold the ON/OFF button until the flashes change from rapid
to slow, or
•
Plug and unplug a powered charging cable into the side of
the transmitter.
•
Connect the microphone by pushing the mic connector
ends together.
Pair the MicCommander and Transmitter
•
The screen on the MicCommander displays the serial
number of paired transmitters. The serial number is on the
transmitter antenna or back.
•
If the desired transmitter is not listed, press the <MENU>
button to either scan for nearby transmitters or manually
add the serial number. Use the arrow buttons to navigate
the menu.
•
Scan: Press <ENTER> to scan. Use the down arrow to select
the transmitter. Use the side arrows to review information
about the transmitter. Press <ENTER> to toggle the selection
“x”. Press <MENU> to access additional search functionality.
Press <Back> to accept the addition of a transmitter to the list.
•
Add: Use the down arrow to select “Add” and press <ENTER>.
Use the navigation arrows to enter the serial number. Hold
the arrow key for rapid scroll. Press <ENTER> to save.
•
Select the desired transmitter and press <ENTER> to go to the
transmitter menu.
Adjust
:
Set the functions in the two transmitter menus of the
MicCommander. Screen one includes frequency, power On/Off,
battery level, mic mute/live and mic offset. To access screen two,
navigate to NEXT> and press <ENTER> to adjust transmitter name,
group, RF power, 2.4GHz channel, storage and reboot.
•
Frequency
: Highlight the frequency and press <ENTER>. Use
the directional arrows to choose the desired frequency. Hold
the arrow for rapid scroll. Press <ENTER>.
•
Mic-Gain:
Set Mic gain to 50% and adjust up or down as
required.
• RF Power
: Select between 10 25, 50, 100 mw A lower power
level will conserve battery life.
•
Storage
: Navigate to NEXT> and <ENTER>. Use the down
arrow to go to STORAGE and press <ENTER>. Navigate to
highlight CONTINUE on the warning screen and <ENTER>.