28
Splay Angle Adjustment
It is easier to set the angles when constructing the array. However, if some adjustments are needed, proceed as follows.
1. Loosen up all the screws to give the array freedom of movement.
2. Lift the rear of the array so the weight is not preventing you from changing the angle. For a small array, this can be done manually.
For a heavier array, or when the array is deployed by a single person, you can use a ratchet strap between the array frame and
the M10 Pullback Point of the last loudspeaker.
3. Change your angles to the new, desired angles (see "Attaching PL-LA to PL-LA" on page 22). Do not torque yet; they should be
loose to allow for movement as you adjust the splay angle.
4. Release the array so that it hangs freely and remove the ratchet strap.
5. Torque everything at 11.3 N∙m (100 lbf∙in) until it is completely secure.
6. Put back the side panel (see above).
Summary of Contents for PL-LA Series
Page 36: ...36...