Q-SYS PL-LA Series, User Manual, Page: 27 / 37

27
Suspending PL-LA Loudspeakers using Two Pull-Back Bars
1. Assemble the array of loudspeakers on the ground using the included mating hardware, as described on page 22.
2. Attach one pull back bar at the top front of the array.
3. Attach the second one to the back rear of the array.
3
1
2
3
2
Figure 24
Optional Eyebolt
When a Pullback Point is needed, an M10 Eyebolt can be used on the rear of the lowest
loudspeaker of small arrays to provide another pick-point for further support to angle the
system.
WARNING!:
Do not exceed the Working Load Limits of the M10 Pullback
Bar Point as stated in "Maximum Suspended Load" on page 13.
Side Panel
1. Once the rigging angles are definitive and secure, you will then need to install the side panel to hide the rigging hardware.
2. Insert the plate into the grommets on the top and the bottom and torque the 3 screws at 1.35 N∙m (12 lbf∙in).
3. Repeat on every loudspeaker.
Figure 26
Figure 25