Q-SYS PL-LA Series, User Manual, Page: 22 / 37

22
Attaching PL-LA to PL-LA
Do not fully torque the screws before the array is mounted and angled, as it will prevent the free rotation needed so gravity can set the
angle as needed.
NOTE:
Remove the side panels from each side of all of the PL-LA loudspeakers before starting the assembly of the PL-LA
loudspeakers.
1. Attach the front of the PL-LA to the next PL-LA loudspeaker.
2. Select the desired angle.
3. Attach slider at the back (ATTACH point).
4. Insert a screw into the corresponding locking hole.
5. Repeat with the next PL-LA loudspeaker.
6. Torque each screw at 11.3 N∙m (100 lbf∙in) when all the PL-LA loudspeakers are installed and properly angled.
NOTE: For large arrays, it may be convenient to assemble 2-3 PL-LA loudspeakers on the ground before attaching them to
the array.
1
2
3 4
1
5
4
3
2
Figure 18