SuperDVR & 8PCRP/8PCDP/16PCRP
User Manual
Q-See
33
3.
Address
Communication address of P.T.Z device (ID number)
4.7.2 Serial Ports Setup
Users should first enable the P.T.Z control function of a certain camera and
select a port number in P.T.Z Protocol Setup (refer to Figure4-18), and then
set corresponding parameters in the area below:
Figure4-19 P.T.Z Serial Port Setup
1.
Port
Users can set port number.
2.
Baud Rate
Set P.T.Z device Baud Rate to match setting on camera, default value is 9600.
3.
Data Bits
Default value is 8.
4.
Parity
Odd and even parity bit, default None.
5.
Stop Bits
Default value is 1.
NOTICE: Users should look at the control board of the P.T.Z device
and get the Baud Rate, Protocol, and Address first, then enter the
same values into the SuperDVR program.
