![background image](http://html1.mh-extra.com/html/q-cells/q-peak-duo-xl-g10-2/q-peak-duo-xl-g10-2_installation-and-operation-manual_3079778012.webp)
22
23
INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO XL-G10.2_G10.c – Q CELLS
INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.PEAK DUO XL-G10.2_G10.c – Q CELLS
22
8 MAINTENANCE AND CLEANING
Q CELLS solar modules are known for a long operating life and
minimal maintenance effort and expense. Dirt and grime are
usually washed away by rain. If the module is fully or partially
shaded by dirt or debris (e.g., plants, bird droppings), it needs
to be cleaned to prevent a loss of performance.
Maintenance
Ä
The PV system has to be inspected regularly by certified
personnel
Ä
The time intervals and extent of the inspection can depend on
local circumstances (e.g. salt, ammonia content in the air, high
humidity etc.). The customer / operator must inform himself
about time intervals and extend of necessary inspections.
Ä
Inspections have to be performed especially after extraordinary
events (e.g. storm, hail, high snow loads etc.)
Ä
During the inspections it has to be checked that the compo-
nents are secure, undamaged and clean
Cleaning
WARNING!
Risk of injury due to hot and live modules!
Ä
Only clean modules that have cooled down.
Ä
Do not carry or wear any electrically conductive parts.
WARNING!
Risk of falling due to unsecured access!
Ä
Never access the installation area alone or without taking
adequate security precautions.
Ä
Please commission a trade specialist.
NOTE!
Module surface damage may occur!
Ä
Remove snow and ice carefully without force (e.g. with a
very soft broom).
Ä
Do not scratch off dirt.
Ä
Module cleaning has to be done by qualified personnel
according to the state of the art and taking into account all
relevant safety issues and general product properties, e.g.,
but not restricted to:
•
electrical safety
•
mechanical stability (load limits depending on the actual
mounting options)
•
chemical suitability (no effect to any of the module's
components, e.g. cable, connector, silicone)
•
no abrasive materials.
NOTE!
Dust and dirt are abrasive materials!
Note! Module damage may occur!
Ä
Do not clean modules with water if there is a
risk of frost.
0°
Ä
Free the substructure from any dirt and debris
(leaves, bird nests, etc.).
Ä
The situation for each individual project (or type of dirt) must
always be professionally evaluated.
Ä
Wrong cleaning may cause damages such as, but not limited
to, damages to the glass surface (e.g. scratches) and AR
coating, power loss, delamination, loss of frame-to-laminate
bond, reduced snow and wind load capability etc.
Apart from the above, each customer is free to choose the method
of cleaning. However, possible damages, caused by the cleaning
or related to the cleaning tools or agents shall not be covered
by the module's Product and Performance Warranty. Therefore
it is recommended to use only the tools and agents which have
already been successfully tested and used with PV modules, to
prevent possible damage.
Isopropyl alcohol (IPA) can be used selectively to remove
stubborn dirt and stains within one hour after emergence.