11
FITTING THE DETECTOR
VII
NOT TO SCALE
VIII
NOT TO SCALE
IX
NOT TO SCALE
1.
Put the mounting base against the surface it is
to be fixed to.
2.
Mark two screw holes, one in each of the
keyhole slots.
3.
Using a 5mm drill bit, drill two holes where the
keyhole marks are.
4.
Insert the two red wall plugs provided into
the holes.
5.
Use the two screws also provided to attach the
bracket. (Fig VII)
6.
Line up the sensing unit making sure its clips
are to the side of the clips on the base. (Fig VIII)
7.
Rotate the sensing unit to secure in place.
(Fig IX)
Please note: Mounting base and sensing unit may differ in appearance to the diagram shown
above however, installation remains exactly the same.
