19
REAR SWITCH FEATURE - SMOKE & HEAT
If the sensor unit is detached or not seated on the mounting base
correctly for 5 minutes or more, immediately after being tested or
powered up, the system will display a detector fault.
Please note: Once the system has indicated a ‘Detector Fault’, it must be cleared using a valid
engineer or user code (subject to system programming).
During this time, the unit’s LEDs will be completely extinguished and there will be no
reaction to pressing the test button.
When reseated correctly, the device will beep and the green LED with flash. After this, test
the device to make sure it is all working correctly. For help refer to ‘Testing the Devices’.
Once the device has indicated to the system that it is now on it’s mounting base correctly, it
will only send an update to the panel
once every 24 hours
.
Please note: During any time period when the device is not seated on the mounting base correctly,
the sensor component of the device is fully powered down.
This means the sensor component of the device which detects smoke or heat will be completely
powered down and the device will provide no protection.
TEMPORARY FAULT MUTE FEATURE - SMOKE & HEAT
This feature temporarily mutes fault warnings for an hour.
To enable, when the detector indicating a fault such as ‘Sensor Low Battery - Smoke & Heat’,
press the test button.
To disable the feature within the hour, press the test button and the detector will return
back to an audible warning.
Smoke Detector
Detector Fault
11-Landing
Detector Fault
