EURO 162/280 Installation Manual
Page: 29
8.2
Connecting The Internal Tag Reader (EURO-PROXI)
The Internal Tag Reader can have 2 inputs connected. It can
be used as a set, unset, entry control or an access control
device.
NOTE:
See the reader installation manual for the LED and
button explanations.
NOTE:
The total number of readers that can be installed on
the EURO 162 is 15, and the EURO 280 is 29. The readers
are installed on the same bus as the keypads.
8.2.1
Technical Specification
EURO-PROXI (Internal Tag Reader)
Input Voltage:
12VDC (9-15V DC range)
Supply Current:
<30mA Quiescent. <90mA Maximum
Inputs:
Programmable. 2 inputs; DEOL
Input EOL Fixed Resistor
Values:
Alarm=4K7 / Tamper=2K2
Normal: 1k4 to 2k9
Burglary Alarm:4k2 to 7k8
Tamper: <1k4 or >22k
Shared Outputs:
Switched negative 150mA (Max)
Colour and Casing:
White 3mm ABS
Indication:
LEDs (Alert, Alarm, Fault, Tamper, Disarmed)
Temperature:
Storage:-20°C to 60°C
Certified: -10°C to 40°C
Nominal: -20°C to 60°C
Dimensions (H x W x D):
97 x 40 x 23mm
Front and rear tamper protected
NOTE:
If the EURO-PROXI (Internal Tag Reader) is programmed as an 'Set/Unset' device, 2 inputs are enabled. If
the EURO-PROXI is programmed as 'Entry Control' or 'Access Control' only 1 input is enabled.
8.2.2
Addressing The Internal Tag Reader (From the Reader)
NOTE
: The addressing is done by adding the relevant numbers on the dip switches:
For example: Dip switch 1 and 2 are only ON = Address 3.
Dip switch 1 and 16 are only ON = Address 17 etc.
