Copyright Pyroban Ltd. Issue 1 Page 10 of 32
Part number PM1083ENG
O
PERATING INSTRUCTIONS
Display Indicators
Note: Not all indicators on the Control Unit are relevant to Gascheka duo.
The Operator's responsibilities are restricted to the actions described in this section of the
manual. The Operator should not perform any servicing or maintenance, remove any covers or
replace fuses. Fuse replacement should be carried out by a suitably qualified/experienced
service engineer.
Pre-start Checks
1. Carry out any pre-start checks recommended by the vehicle manufacturer.
2. Check the general condition of the vehicle and Pyroban equipment as defined in
the Routine Servicing section of this manual.
3. Ensure the valve on the Pyroban test gas cylinder is turned to the ON position and
that the cylinder is not empty.
If there is any doubt as to the satisfactory condition of the vehicle or Pyroban
equipment, the Person in Authority must be consulted and any faults rectified
before the vehicle may be used.
4. Switch on the Gascheka duo isolator. Confirm that the green power indicator on
the Control module is lit.
Dallas receptacle
7 segment status
indicator
Gas Warning
Indicator
Vehicle
Operational
Indicator
Refer to
Manual
Indicator
Power Indicator
Gas Test progress
Indicators
