5.14.2
Error message
The device is equipped with a built-in memory work control function.
If there are problems with the memory operation on the PX714 display, the
Err
message appears – memory error.
In this situation, select the “
enter
” key. The device will reload the default
configuration and upload it to the memory. If after this operation, the
Err
message remains on the screen, the memory is permanently damaged and
the unit must be sent to the service point.
6
DMX signal connecting
PX714 have to be connected to DMX line in serial mode, with no branches
on DMX control cable. That means that DMX line, from the signal source,
must be connected to
DMX IN
pins of PX714 and later, directly from
DMX OUT
pins to the next device in DMX chain.
If the PX714 is the last DMX chain receiver there should be terminator
(resistor 120 Ohm) mounted between "
DMX+
" and "
DMX-
" pins of
DMX OUT
section.
26
