•
Ballast fail – values: Yes / No;
This indicates that the lamp responds an error
•
Power On Event – values: Yes / No;
Displays the lamp reports that it has been switched on
•
Limit error – values: Yes / No;
Displays info about the state when
brightness level limits has been exceeded
•
Reset state – values: Yes / No;
This indicates that the lamp has been reset
•
Unknown address – values: Yes / No;
This indicates that the lamp has lost its address
7.1.2 Ballasts reset
Ballast reset
allows to restore the default settings for all ballast and each
individual. To reset all ballasts at the same time, select the
All ballasts
option.
After confirm with the
enter
button, a message about the execution of the
operation:
Ballast Reset OK
will be showed.
When a single ballast reset is needed you need to select desired ballast
and then proceed as in the case of all ballast reset. If you try to reset the
ballast is not found by the device there will be an error message displayed
Reset ERR
.
13
