sample connection of LED strip
18
20. CONNECTION SCHEME
Due to use of passive-type DMX in the PX282 driver, a terminator is needed at the end of DMX
line. Such a solution allows to connect up to 32 of the PX282 drivers to a DMX controller (serial
connection).
The connections have to be made with wires of appropriate gauge. The proper connection lowers
the risk of damaging the driver and improves its reliability. For DMX signal connection use the
shielded conductors only.
CAUTION:
In case of voltage loss on one of the modules in a chain, this one and the subsequent
modules will not respond to a DMX signal.
typical LED strip
12-24V DC
power supply
DMX controller
to next modules
GND
DMX-
DMX+
1
2
3
4
5
6
PX015
1
2
3
4
5
6
Chaser
Scene
Club 6p
90
% 100
80
70
60
50
40
30
20
10
0
100 %
90
80
70
60
50
40
30
20
10
0
Master
Music
Speed
B
G
R
+12
V- V+
L N
www.pxm.pl
DMX IN
DMX OUT
GND
GND
OUTPUTS
B –
G –
R –
PX282
12-24V DC
R
R
R
www.pxm.pl
DMX IN
DMX OUT
GND
GND
OUTPUTS
B –
G –
R –
PX282
12-24V DC
schematic connection of LEDs
Please note that the
driver is
common anode type device!!!
It is possible to connect lamps
with 4-wires cable with a only!
PX282
Caution!! For power supply connection, use only
cable of minimum 2.5 mm cross-section
2
