28
IPT
V Str
ea
ming
out
DATA IP
This section sets the Physical ip address of the IPTV Streaming port.
The ip port address and the nms port address used for the remote control CANNOT be set to the same network.
As example, the Remote control port can be on network 192.168.0.xxx and the IPTV port can be 192.168.3.xxx
Should you use multiple units, make sure the mac address is set to a different value between units ( just change
the last digit and apply )
Unless required by your application THERE IS NO NEED TO CHANGE THE DATA IP VALUES, as these
will work AS IS for your in-building multicast application. Use the values as on the picture.
SPTS
This section sets the multicast IP ADDRESS and PORT as well the format for the two encoders streaming
Mode
= Select if the stream mode for the channel 1 and 2 ( hdmi input 1 and 2 )
Usually use UDP as it passes most of the existing switches
Use RTP Only if your switch and network requires RTP
Default = 1/2 UDP
NULL PKT Filter
= Enable or disable the filtering of the Null Packets on each output stream
Default = 1/2 Selected
OUTPUT IP
= Set the MULTICAST ADDRESS for the two streams
Default = 224.2.2.2
DST PORT
= Set the MULTICAST PORT to use for the streaming
Default = 1001 for the first stream and 1002 for the second stream
SRC PORT
= The src port you want to use to find the streams, used on some players
Default = 5001 for the first stream and 5002 for the second stream
TTL
= The TTL time the network requires and accepts
Default = 128 for the first stream and 128 for the second stream
Please set and apply the changes individually, one by one, per each of the channel
( set one channel / apply - then set the other channel / apply )
MPTS
This section sets the multicast IP ADDRESS and PORT for the MULTI PROGRAM Transport stream
( two channel in one stream )
WARNING : TUNRING ON THE MPTS WILL DOUBLE THE TRAFFIC ON YOUR IP NETWORK.
THIS MIGHT CAUSE SERVICE DISRUPTION DEPENDING FROM THE PERFORMANCES OF YOUR SWITCH.
WE STRONGLY SUGGEST TO KEEP THE MPTS OFF UNLESS NEEDED.
Mode
= Select if the stream mode for the mpts multiplexed stream ( two channels in the same ip stream )
Usually use UDP as it passes most of the existing switches
Use RTP Only if your switch and network requires RTP
Default = UDP
NULL PKT Filter
= Enable or disable the filtering of the Null Packets on each output stream
Default = Selected
OUTPUT IP
= Set the MULTICAST ADDRESS for the two streams
Default = 224.2.2.2
Summary of Contents for VeCOAX MicroMod-2
