4)
Hold the valve body in one hand and press the disconnect bar (7) into the fluid
body (1) using your thumb. At the same time using your other hand, grab the top
of the servo motor (16) and pull the motor with coupling (17) and auger (14)
assembly out of the fluid section to completely remove it from the valve.
Note: There will be a spring force against the disconnect bar to force it away from
the fluid body.
5)
Using a cloth, clean all material from the auger (14).
6)
Then using a q-tip or other cleaning utensil wipe the luer adapter (15) and fluid
body (1) clean of all material.
7)
Using a 0.9 mm Allen Key loosen the set screws of the flexible coupling (17) to
remove the auger (14) from the coupling then the coupling from the motor (16).
8)
Using a Pick, remove the Viton o-ring (18) from the auger.
9)
Then using a 1.5mm Allen Key, remove the 3 machine screws (19) that secure the
motor collar (4) to the motor (16) to separate those sections.
10)
To disassemble the valve body, first use a 3/32” Allen Key to unthread and
remove the 4 machine screws (12) that secure the syringe holder (8) to the
standoffs (9) to remove the syringe holder.
11)
Next, use an adjustable wrench to unthread and remove the standoffs (9) from the
fluid body (1).
12)
To remove the luer adapter, use a press and press tool. First place the press tool
(114-5375) on the inside of the fluid body (1) on top of the luer adapter (15) and
push the luer adapter out of the fluid body.
13)
If necessary, use a 0.050” Allen Key to unthread and remove the four machine
screws (11) from the valve body to remove the two quick disconnect covers (6)
and remove the components of the quick release mechanism.
Assembly Instructions
General
The o-ring (18) must be lubricated with a small amount of silicone grease.
A small amount of removable thread locker should be applied to the male threads of
the standoffs (9) and the male threads of the lock knobs (5).
Summary of Contents for SV200
Page 10: ......
