Tool Kit
PVA offers standard tool kits for all dispensing valves. The tool kit for the SV200
is part number
B12-3419
, which includes all necessary tools and lubricating grease to
perform maintenance on this dispense valve:
B12-3419
Includes:
Qty Part
Number
Description
1 0266244
8”
Adjustable
Wrench
2
V004
0.9 mm Allen Key
1
6958A21
1.5 mm Allen Key
1
7122A38
0.050” Allen Key
1 26559
1/16”
Allen
Key
1 26563
3/32”
Allen
Key
1
9570K71
Hook and Pick Set
1
B62-2048
Silicone Lubricant for O-Ring
1 114-5375
Press
Tool
Operation
Refer to assembly drawing
112-4396
for part reference numbers.
1)
Connect the valve to the controller as outlined above in the
Setup
procedures.
2)
Cycle the valve and make sure the flexible coupling (17) and auger (14) spin in
the forward direction during dispense and the reverse direction when it stops.
3)
Connect the syringe to the valve using the feed tube connector (20).
4)
Mount a universal air cap to the syringe and connect the air line to the 5/32” tube
quick connect on the SVC100 controller.
5)
Cycle the valve to the dispense position to feed material through the luer adapter
and purge all air.
6)
Set the syringe air pressure to feed fluid to the auger.
7)
Adjust the motor speed to the desired flow rate.
8)
Adjust the reverse time to obtain a clean shutoff of fluid flow.
Note: Refer to
Troubleshooting
section for any problems.
Periodic Maintenance
The o-ring (18) mounted on the auger will need to be replaced as wear occurs.
Summary of Contents for SV200
Page 10: ......
