DeltaTherm IR Cure Module
Revision B
/
February 2020
Page 18 of 41
Auto Cycle
Auto Cycle is the normal operating mode for the DeltaTherm IR Cure Module. In Auto Cycle,
the cure module can operate as part of a production line. All communication with adjacent
machines is done without operator input. In Auto Cycle, the machine uses the parameters in
setup mode. The screen below shows Auto Cycle with four zones top and bottom.
Figure 11: Auto Cycle
1.
The
Panel Temperature
shows the current temperature of the heater panel.
2.
The
Panel Temperature Setpoint
shows the current recipe’s temperature setpoint
of the heater panel.
3.
The
At
Temperature
indicator will light up when the panel temperature is within
the allowable setpoint deviation value.
4.
The
Current
Recipe
Name
will display at the top of the screen.
5.
The
Board
Counter
displays the number of boards in the oven. In the event of an
incorrect value (PIP flashing), press and hold for 5 seconds to reset this to zero
6.
The
Autocycle Messages
section displays the current Auto Cycle state and status
messages.
7.
Press to the
Heater Panel Trend
icon to view a graph of panel temperature values
over time.
8.
To view the next set of panels and zones, press the
Next Zone
button.
9.
The
SMEMA Status
shows the current status of SMEMA inputs and outputs.
10.
The current
Conveyor Speed
will display at the bottom of the screen.
