P
USH
C
ORP,
I
NC.
AFD92
Manual
6
3.2.1 Mounting the Horizontal
AFD92
The
AFD90
-2 is supplied with a standard Mounting Bracket shown in Figure 2. A
minimum of (3) three holes should be utilized to secure the Mounting Bracket to the
robot mounting flange.
Figure 2. AFD90-2 Mounting Bracket
If additional holes are required, it must first be removed from the device before drilling.
Four (4) M10x1.5 Socket Head Cap Screws are used to attach the Mounting Bracket to
the
AFD92
force device. Once the Mounting Bracket is removed, mounting holes may
be placed anywhere within the crosshatched area shown in Figure 2.
PushCorp, Inc.
can supply engineering support to determine the mounting hole locations at no cost.
After drilling the required hole pattern, remove any burrs and clean any machining
residue from the Mounting Bracket. The Mounting Bracket dowel pin holes must be
aligned before it can then be reattached. The fasteners should be torqued to the
specification in Section 7.0.
Copyright
PushCorp, Inc.
2006. All rights reserved