PURSUIT 2870 Walkaround, Owner'S Manual

Page: 42 / 140

2870 WALKAROUND
Accessory Switches (3)
These switches are supplied to protect additional equipment that may or may not have been installed
by Pursuit or your Pursuit dealer. If no accessories are activated by these switches, they remain
wired in the panel in reserve. Some accessories that may be connected to the accessory switches
are: The hardtop lights, spreader lights, or electronics.
12-Volt Receptacle
Provides electrical current for portable 12-volt equipment.
Additional Accessory Switch Panels
Additional switch panels are located in various locations in the cockpit and helm area of the boat.
Most of these panels are equipped with one switch and one circuit breaker. The following is a
description of additional panels that may be on your Pursuit and the accessories they control:
Baitwell Switch
Located under the gunwale in the cockpit near the livewell. This switch activates the baitwell
circulating pump that supplies water to the baitwell.
Washdown Pump
Activates the washdown pump pressure switch located on the pump. The pressure switch
automatically controls the water pump when the system is activated and properly primed. It is
protected by a circuit breaker in the panel and an automatically resetting breaker on the pump motor.
Note: Please refer to the Raw Water chapter for more information on the baitwell and
washdown systems.
Trim Tab Switch
Located in the helm. This switch controls the trim tab planes located on the transom of the boat. It
is protected by the accessory breaker located in the 12-volt helm switch panel. Please refer to the
Helm Control Systems chapter for detailed information on the operation of the trim tab controls.
Engine Trim and Tilt Switches
Located in the helm. These switches may be installed in the engine control handle or on the helm
console, depending on the engines installed in your boat. They control the trimming and tilting of
the engines. Please refer to the Helm Control Systems chapter and the engine owner's manual for
information regarding the proper use of the tilt and trim switches.
Fuel Gauge Switch
The fuel gauge switch panel is located at the helm and allows
one fuel gauge to be used for both fuel tanks. With the
ignition switch on, move the switch to port and the gauge will
show the fuel level in the port fuel tank. Move the switch to
starboard and the gauge will show the fuel level in the
starboard tank.
4-4
Fuel Gauge Switch