Purite SELECT FUSION 160, Operator'S Manual, Page: 56 / 89

OPERATING MANUAL FOR SELECT FUSION
•
Switch off the unit and isolate the mains water supply.
•
Open the front door cover; the
Puripac PP-8 cartridge
is located
to the left.
•
Press down the
Blue
lever on top of the holder and gently pull
away the exhausted cartridge.
(See Fig-27)
. There may be some
drops of water lost from the cartridge.
•
The cartridge can now be disposed of, refer to
Section 9.4
for
advice on disposal.
•
To refit a new pack simply remove it from its packaging. Be sure
to remove the two black plugs used to seal the two ports,
(see
Fig-11).
•
Then slide the pack back into the holder. The locking lever will
“Click” indicating the pack is secure.
•
Switch on the electrical supply and turn on the water. Select
“
Start
” from the menu screen. The unit should now ask you to
confirm that a new pack has been fitted followed by a request to
reset the next exchange date, just follow the simple on screen
commands.
•
NB
If the new pack has not located correctly, the sensors located
in the pack holder will set off an alarm and raise a corresponding
alarm message on the screen, i.e.,
“Fit PP8 (Left) Pack”
. Refer
to
Section 8 Troubleshooting
should this occur.
7.3 REPLACING THE NCP CARTRIDGE PACK
•
Simply follow the same procedures as laid down for the
Puripac
PP_8 cartridge
in 7.2 above.
•
The NCP cartridge pack is located to the right of the Puripac
cartridge and can be released by depressing and holding down
the, White, lever.
•
NB
If the new pack has not located correctly; the sensors located
in the pack holder will set off an alarm and raise a corresponding
alarm message on the screen, i.e.,
“Fit NCP (Right) Pack”
. Push
the cartridge fully into the retainer. Refer to
Section 8
Troubleshooting
should this not cure the alarm.
Iss: F 17.03.08