9
3. While pairing mode is active, close the battery doors on both hearing
instruments and make sure they are ON. A successful pairing will be
indicated by an audible melody played in both hearing instruments. Also
the LED on the Phone Clip will remain lit (yellow) for 2 seconds.
If your mobile phone is Bluetooth enabled and supports the appropriate
profiles, it can communicate with the Phone Clip 2 only after completing
two simple procedures: pairing and connecting.
The pairing procedure allows you to control which Bluetooth devices are
permitted to communicate with each other. It needs to be completed only
once for each device you wish to use with your Phone Clip 2.
You can pair up to 8 Bluetooth devices with the Phone Clip 2, but only 2
Bluetooth devices can be connected/active at a time.
The pairing procedure is described in the following section. Once a mobile
phone is permitted to communicate with the Phone Clip 2 by the pairing
procedure, the connection procedure configures the device to actually
output its audio signal over the Bluetooth connection. This procedure is
also described in the following section.
Pairing to your mobile phone
The pairing procedure is controlled by your mobile phone. Different mobile
phones have different menu structures. You should therefore refer to your
mobile phone’s manual if you cannot complete the pairing procedure with
the generic steps described here.
Bluetooth Pairing
