11
Copyright © Puretec Pty Ltd 2016
Puretec MUL -E1 User Guide
Position the Multitrol System on a level surface.
Environmental conditions:
Operating temperature: 2-48°C
Water conditions
Temperature:
1-50°C
Pressure:
140-875 kPa
4
Installation
Media Installation
The Media has been shipped separatly to avoid damage in transit.
The length of the internal riser pipe is pre-set and does not need adjustment.
1.
Position the system on a flat surface close to a drain or a properly
trapped outlet, in a position when the system can service all lines
requiring treated water. The system should be placed far enough
away from any water heaters to avoid any hot water backflow
into the system. A weatherproof powerpoint and surge protector is
recommended.
2. Plug or cover the top end of the riser pipe in the tank making sure no
media can enter the tube.
3. Ensure that the riser pipe is sitting in the cradle at the base of the tank.
Then using a wide mouth funnel, place the media in the tank as per the
numbering on the buckets. (Buckets are labelled 2, 3 etc. Put No. 2 in
first, followed by 3, etc. as required.)
Note: vessel and head are always labelled as No.1.
4.
Remove the plug or cover from the riser pipe making sure you do not lift
the riser pipe. Top up tank with water. Screw valve onto the tank (hand
tight is usually sufficient), making sure the distributor tube is properly
inserted into the valve.
5
