Edition from 05.06.2015
3
PLCM-E1b.
CNC Ethernet controller
www.purelogic.ru
8 (800) 555 63 74
01
02
General information
Delivery set
Technical features
The device is a controller of PLCM series ( see user’s manual), has
input/output port and Ethernet interface for PC connection. This port
corresponds with LPT-port of PC in form and location.
• Controller PLCM-E1b — 1 pcs.
• Instruction manual PLCM — 1 pcs
• Installation and setup guide PLCM-E1b — 1 pcs
• Ethernet cable — 1 pcs
03
01. General information
Voltage supply
Max current consumption
Max number of axes of CNC-machine
Operating temperature
Overall dimensions (W x H x L)
Control interface
STEP Max signal frequency
Number of outputs
Isolation resistance
Module’s height (without packing)
Number of inputs
12V, direct current
6
0...50 °С
83 х 27 х 66 mm
250mА
100 kHz
12 items, buffered 5V, 10mA MAX
500 mOhm
0.3 kg
5 items, buffered logic levels
“0”<1.8V, “1”>2.5V.
Max input voltage is 15V
Ethernet, connector “RJ-45”.
signal transmission STEP/DIR/
ENABLE and input signals.
MACH3-compatible
!
Check
www.purelogic.ru
for more information.
POWER OFF DEVICE BEFORE MAKING ANY CONNECTIONS.
DO NOT CONNECT POWER SUPPLY’S «-» TO GROUND, MASS,
HOUSING, ETC.
IT IS RECOMMENDED TO USE HIGH QUALITY NOISE-PROOF CABLES
ETHERNET ( 5TH CATEGORY AND HIGHER)
THE CONTROLLER WORKS WITH MACH3 R3.043.XXX VERSIONS AND
HIGHER, ALWAYS REMEMBER TO UPDATE MACH3.
• For controller power supply, direct current source is used, supply
voltage is 12V.
• Ethernet connector is designed for PLCM-E1b connection to local
area network. The connection must be performed with cable 5 or of
higher category, You can apply patch-cords with straight through or
crossover crimping type. Direct connection to PC without commutator
usage is possible.
Main connectors and indicators
04
