PureLink by Dtrovision
39
Select Output #
Selected Output's display device's EDID information will be displayed
Select empty slot on EDID library where selected EDID data will be saved on to.
Push enter button to save.
EDID status display:
o
Write OK : EDID save process was successfully completed
o
N.C : Not connected, when Output Board or monitor are not installed, or detected.
o
Write Err : Write error, when EDID save process was not successfully completed.
2. Router ID
- By setting different ID to the Matrix Router, up to 255 units of PM series Matrix
Router can be connected and operated in the same network either via serial or
LAN communication. Router ID can be set between 001 ~ 255.
* Factory default setting is 001
Note) Router ID is associated with commend control Protocol; therefore, it is
important to remember Matrix Router's current Router ID.
3. RS232
- There are four values those need to be set for serial communication; baud rate,
data bits, stop bits, and parity. Click and select each value using touch screen
and push enter button to save.
Factory default (recommended) settings for serial communication are:
Baud rate - 19200
Data bits - 8
Parity - none
Stop bits - 1
Flow control - none
and supported settings are:
Supported Baud Rate: 4800 Bps, 9600 Bps, 14400 Bps, 19200 Bps,
38400 Bps, 57600Bps, 76800 Bps, 115200 Bps
Supported Data bit: 5 bit, 6 bit, 7 bit, 8 bit
Supported Parity: Non, Even, Odd
Supported Stop bit: 1 bit, 2 bit
