User Manual
IPAV Pro Series
19
3.5
IPAV1102-TX
The IPAV1102-TX transmitter is integrated by two IPAV1100-TX. Here take one of
transmitters as an example to describe its interfaces.
①
HDMI IN:
Type-A female HDMI port for HDMI video source device.
②
DP IN:
DisplayPort input port for DP video source device.
③
CAT (10G):
RJ45 port to connect directly to the RX or a network switch using
Cat6a / Cat7.
④
FIBER (10G):
LC port to connect directly to the RX or a fiber network switch using
an optical LC cable.
⑤
RS232:
RJ11 (6P4C) port for RS232 control. Supports point to point unicast and
one to all broadcast configurations.
⑥
AUDIO IN:
A miniXLR (5pin) port to connect a balanced audio source.
⑦
ETHERNET (1G):
RJ45 port to connect control devices (such as PC) for system
control via software and Ethernet pass-through. The PC can also be indirectly
connected to the network switch.
⑧
Signal LEDs:
POWER LED:
The LED illuminates red when power is applied.
LINK LED:
The LED indicates if Ethernet packets are transmitted.
LED off: Packets are not transmitted.
LED blinking: Packets are transmitted.
LED on: packets are not transmitted but link is present.
HDMI LED:
The LED illuminates green when the HDMI video source is selected.
DP LED:
The LED illuminates green when the DP video source is selected.
⑨
220~240V AC IN:
Power connector for AC input.
1
8
9
2
3
4
5
6
7
