User Manual
IPAV Pro Series
22
6)
Ensure the module aligns with the desired card slot before tightening the screws.
7)
Using a screwdriver and the supplied screw, fasten the Rear Module to the frame
back plane. Do not over tighten.
8)
Ensure proper frame cooling and ventilation by having all rear frame slots covered
with Rear Modules or blank metal plates.
To install a Front Module in an OG3-FR series frame:
The slot number is dependent on the slot combinations you installed the Rear Module
in. This allows adequate spacing to avoid damaging the card, the cards installed in the
neighboring slots, or both.
1)
Locate the rear module you installed.
2)
Open the frame door as follows:
Gently pull the side door tabs towards the center of the door, releasing the door
from the frame.
Using both hands, pull the door towards you. The door extender arms prevent
the door from falling.
