www.pulsar.pl
PSBOC1001270
5
Temperature characteristics.
Chart 1.
Acceptable output current from the PSU
depending on ambient temperature.
Mechanical specifications (tab. 3).
Enclosure dimensions
199 x 97x 42 +23 [mm] (LxWxH) [mm] (+/- 2)
Net/gross weight
0,63kg / 0,68kg
Connectors
power supply, technical outputs:
Φ
0,63÷2,5 I/O PCB :
Φ
0,41÷1,63
BAT battery outputs: 6,3F-2,5/40cm,
Led indication output: 3-pin 5 mm connector
Operation safety (tab.4).
Protection class PN-EN 60950-1:2007
I (first)
Degree of Protection PN-EN 60529: 2002 (U)
IP20
Electrical strength of insulation:
- between PSU input circuit and output circuits (I/P-O/P)
- between input circuit and PE protection circuit (I/P-FG)
- between output circuit and PE protection circuit (O/P-FG)
3000 V/AC min.
1500 V/AC min.
500 V/AC min.
Insulation resistance:
- between input circuit and output or protection circuit
100 M
Ω
, 500V/DC
Operating specifications (tab.5).
Operating temperature
-10ºC...+40ºC
Storage temperature
-20ºC...+60ºC
Relative humidity
20%...90%, without condensation
Vibrations during operation
unacceptable
Impulse waves during operation
unacceptable
Direct insolation
unacceptable
Vibrations and impulse waves during transport
PN-83/T-42106
2. Installation.
2.1 Requirements
The buffer PSU is to be mounted by a qualified installer, holding relevant permits and licenses (applicable
and required for a given country) for 230V/AC interference and low-voltage installations. The unit should be
mounted in confined spaces, in accordance with the 2nd environmental class, with normal relative humidity
(RH=90% maximum, without condensation) and temperature from -10°C to +40°C.
The device shall be mounted in a metallic enclosure (a cabinet, an intended case). In order to fulfil LVD and
EMC requirements, the rules for: power-supply, encasing and screening shall be followed, according to application.
The PSU provides voltage of U=13,8 V DC with current capacity:
1. Output current 6A + 1A battery charging
2. Output current 5A + 2A battery charging
Total device c battery: 7A max.
2.2. Installation procedure.
1. Before installation of the power supply unit, make sure that 230VAC power if cut off.
2. Mount the unit in the intended location.
3. Connect the 230VAC power cables. Connect the PE cable (yellow-green) to an appropriate PSU
terminal (marked with
- earth symbol).
