Removal of Seat - Front & Rear
• Remove ‘Side Cover’ LH.
• To remove Seat Front, pull the ‘Seat
Release Cable’ (A) to release seat lock.
Keeping cable pulled, tap the center of
seat, lift the seat from rear end and slide it
back to remove seat.
• To remove Seat Rear, pull the ‘Seat
Release Cable’ (B) to release seat lock.
Keeping cable pulled, tap the center of
seat, lift the seat from rear end and slide it
towards tail lamp to remove seat.
Caution :
Always remove Rear Seat first.
Fitment of Seat - Front & Rear
• For fitment of Seat Front, match & insert
the bracket (‘1’ of Fig. ‘B’),
of seat with slot (‘2’ of Fig. ‘B’)
provided
below fuel tank rear mounting on chassis.
Push seat towards fuel tank and align lock
rod (‘3’ of Fig. ‘B’) & seat lock (‘4’ of Fig.
‘B’). Then press the seat in middle from top
to lock the seat.
• For fitment of Seat Rear, match & insert the
bracket (‘5’ of Fig. ‘C’) of seat with slot (‘6’
of Fig. ‘C’) provided below fuel tank rear
mounting on chassis. Push seat towards fuel
tank and align lock rod (‘7’ of Fig. ‘C’) &
seat lock (‘8’ of Fig. ‘C’). Then press the
seat in middle from top to lock the seat.
Caution :
Always fit Front Seat first.
Fig. B
1
2
3
4
Fig. C
5
8
6
Seat Release Cable
A
B
How to Ride Your Bike
Location of Parts
th
th
From 5 to 4
th
rd
From 4 to 3
rd
nd
From 3 to 2
nd
st
From 2 to 1
50 km/h
40 km/h
30 km/h
20 km/h
Braking :
• Close throttle completely, leaving clutch
engaged so that engine braking will help slow
down motorcycle. Shift down one gear at a
time so that you are in Neutral when you
come to a complete stop.
• When stopping, always apply both brakes at
same time. De-clutch as necessary to keep
engine from stalling.
• Never lock brakes, it will cause tyres to skid.
When cornering, use brakes judiciously & do
not de-clutch. Reduce speed before you get
into the corner. For emergency braking,
disregard downshifting, & concentrate on
applying brakes as hard as possible.
not shift at such high speed that the engine rpm
jumps excessively. This may cause engine
damage, and rear wheel may skid. Downshifting
should be done at recommended speeds.
Gear Shifting Lever
Caution :
Do not operate starter continuously
for more than 5 sec. Wait for 15 seconds
before re-start.
Note :
The motorcycle is equipped with a
starter lockout switch. The starter switch will
operate only when transmission is in neutral
or clutch lever depressed.
Moving Off :
•
Check that Center/Side stand is up.
st
•
Depress clutch lever, shift into 1 gear.
•
Open throttle and release the clutch lever
slowly and simultaneously, as the clutch start
to engage, open throttle a little more, giving
engine just enough rpm to keep running.
Shifting Gears :
•
Close throttle & depress clutch lever.
•
Shift into next higher or lower gear.
•
Open the throttle and release the clutch lever
slowly and simultaneously.
Warning :
When shifting down to lower gear, do
Starting the Engine :
1. Turn
/
2. Turn ignition/ kill switch to ON position.
3. Confirm that transmission is in neutral.
4. Keep the throttle completely closed.
5. Push starter button until the engine starts.
fuel tap to ON RES position.
7
9
10
