www.PyleUSA.com
3
OPERATION
1.
Speakers ON/OFF Button:
Press button to turn
ON
all speaker pairs.
Press button again turn
OFF
.
2.
Amplifier A/B Selector Button:
Press button to select amplifier A and B.
3.
Volume Controls:
Turn the control knob clockwise to increase the volume and
counter-clockwise to decrease or off.
4.
Speaker Connections:
The control center divides the power from your receiver/
amplifier differently to its speaker terminals. (This is especially noticeable when
you connect only one pair of speakers. If you connect more than one pair of speakers,
see "
Impedance Chart
" on page 4 to selector the best terminals to connect.)
For the best performance, make the connections based on how frequently you use
each set of speakers.
Cautions:
To avoid damaging your speakers or receiver/amplifier:
•
Be sure your receiver/amplifier's power is turned off before you make the
connections.
• Never let the speaker wire's bare ends touch each other or the adjacent terminals
on the control center.
• Do not connect more than one pair of sepakers to each set of terminals.
5.
Amplifier Connections:
Connect the speaker output of your receiver or amplifier
(100 watts max). lf you are using a second amplifier, connect it to the B amp terminal.
Maximum Amplifier input
• 100W RMS
• 150W AVG
Maximum Output per Speaker
• 18W RMS
• 50W AVG
• 100W PEAK
• 4 or 16 OHMS LOAD
Insert the speaker’s positive (+) wires in the positive terminals, and negative (-) wires
into the negative terminals, according to the respective L (left) and R (right) terminals.
