PSC LazerData 12000 Series, Installation Manual

Page: 14 / 58

Installation Manual LazerData
®
12000 Scanner
General Features - 1.3
Electrical connection is provided through a cable on the side of the reader. This
cable is terminated with a 25-pin connector (25-pin connector models, see section
1.3, Figure A,
1
) or by a junction box (junction box models, see section 1.3,
Figure B,
1
).
The laser beam output window (Figure A,
10
) is on the right-hand side of the
scanner. A green LED on the same side indicates the laser is active (Figure A,
9
).
A built-in safety system allows the laser to turn on only after the motor has reached
the correct rotational speed. The laser beam is therefore generated after a slight
delay from scanner power up.
The four LEDs on the left-hand side of the scanner indicate the following:
POWER ON
red – (Figure A,
3
) indicates the reader is connected to the
power supply
GOOD READ
red – (Figure A,
4
) is used to signal successful bar code
decoding. It is also used in Test mode to signal the decoding
percentage (for details refer to the section "Test Mode" in the
LDHOST Help Online)
EXT TRIG
yellow – (Figure A,
5
) indicates the code presence sensor is
active (for details refer to the section "On Line Mode" in the
LDHOST Help Online)
TX DATA
green – (Figure A,
6
) indicates data transmission on the main
serial output line
The screw holes (Figure A,
2
) on the body of the reader are for physical
attachment. The screw holes shown in Figure A,
11
are for the attachment of
accessories, such as the optional 90° mirror.