Transferring Files and Data
3-4
Falcon
®
PT40
Connection
Enter the
Connection
port for file transfers. Select from the list
of detected serial ports or modems.
Baud Rate
Select a
Baud Rate
for serial communica-
tions from the pull-down list. The default
value for XFER32 is
19200
. The default
value for the PT40 is
9600
.
Note: The PT40 supports only baud rates
up to
38400
.
Protocol
Select either
XModem
or
ACK/NAK
as
the file transfer
Protocol
for sending and
receiving files.
NOTE:
ZModem
Protocol is NOT sup-
ported by the Falcon PT40.
NOTE: The PT40 defaults to the
ACK/NAK
protocol unless you
select
XModem
. XFER32 defaults to the
ZModem
Protocol.
ACK/NAK
and
XModem
Protocol are the only two protocols
supported by the PT40.
Maximum Errors Enter the maximum number of
Errors
permitted before a file
transfer is aborted. Range:
1
to
50
.
0
specifies no limit to the
number of file transfer errors.
Flow Control
Select the mechanism used to control the
flow of data. Sender and receiver must
agree on the flow control method.
Note:
RTS/CTS
is the default. Use either
None
or
RTS/CTS
.
XON/XOFF
is not supported by the PT40.
None
No flow control used.
XON/XOFF
NOTE:
ZModem
Protocol is NOT supported by the Falcon PT40.
This feature is only available with
ZModem
protocol.
RTS/CTS
Hardware flow control that uses
Request to Send
(
RTS
), and
Clear to Send
(
CTS
) serial port lines to communicate when to
suspend and resume data transfer.
Window Size
NOTE:
ZModem
Protocol is NOT supported by the Falcon PT40.
This feature is only available with
ZModem
protocol.
2340.book Page 4 Wednesday, January 29, 2003 12:50 PM
