Lynx.GX Installation and Management
First Edition, January 2004
Copyright and Service Marks
Copyright © 2004 by Proxim Corp. All rights reserved. No part of this book may be reproduced without prior
written permission from Proxim Corp.
The information contained in this book is subject to change without notice. Proxim shall not be liable for errors
contained herein or for incidental or consequential damages in connection with the furnishing, performance, or
use of this book or equipment supplied with this book. Proxim makes no warranty of any kind with regard to this
book or any equipment supplied with this book, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose.
Tsunami™ and Tsunami.GX are trademarks of Proxim Corporation.
Lynx™ and Lynx.GX™ are trademarks of Proxim Corporation.
OpenView® is a registered trademark of Hewlett Packard Corporation.
Windows® is a registered trademark of Microsoft Corporation.
Other names are trademarks of their respective owners.
Y2K (Year 2000 Issue):
All software supplied by and for Proxim products adhere to the 4-digit year
nomenclature as required for Year 2000 compliance.
Regulatory Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Shielded cables and I/O cords must be used for this equipment to comply wit the relevant FCC regulations.
Changes or modifications not expressly approved in writing by Proxim may void the user’s authority to operate
this equipment.
This device complies with Part 15 of FCC rules and RSS-210 of Industry Canada. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
WARNING!
This device must be professionally installed. Instructions for setting the transmitter RF output power are
referenced in “Adjust Output Power” on page 27. This device is to be used exclusively for fixed point-
to-point operation that employs directional antennas. Be sure to read “Product Safety Instructions”
above before installing this product.
Notices
2
