Proware EP-4643S2D2-F8S6, User Manual

Page: 49 / 151

Fibre to SAS/SATA Disk Array
User Manual 49
Chapter 3 Getting Started with the Disk Array
3.1 Installing the Rails and Mounting into Rack
NOTE: At least two persons are needed to lift the Disk Array. To
reduce the weight of the Disk Array, remove the power supply
modules from the rear of Disk Array. If disk drives are already
installed in the disk trays, remove also the disk trays. Refer to
appropriate sections on how to remove the power supply modules
and how to remove the disk trays/disk drives.
NOTE: The sample model used in the following installation might
not be the actual model for this manual.
NOTE: The Disk Array must be installed near the Disk Array or host
system where it will be connected. A Phillips screwdriver is needed
in installation.
WARNING! It is prohibited to put other enclosures on top of the
64-bay Disk Array because the total weight will not be supported
by the rails.
Steps:
1. Open the rail box.
2. Remove the 2 rail assemblies and the screws/accessories from the box. Check
its contents.