NAS System
18
User’s Manual
2.6 Preparing the System
1.
Attach network cable to Ethernet port LAN0. Connect the other end to your
network switch. You may also connect the other Ethernet LAN port if needed.
2.
Connect monitor to the VGA port.
3.
Connect PS/2 keyboard and mouse to the USB-to-PS/2 converter cable, and then
connect the USB connector to the USB port on the NAS.
2.7 Powering On
1.
Plug in the two power cords into the AC Power Input Socket of PSU located at the
rear of the NAS system.
NOTE: The NAS system is equipped with redundant, full range
power supplies with PFC (power factor correction). The system
will automatically select voltage.
2.
Open the protective cover of the Toggle Switch. And press the toggle switch to
redundant power supply mode.
3.
Press the Power On/Off Switch to power on the NAS.
4.
The Power LED on the front Panel will turn green.
5.
Follow the steps in the next chapter to configure a RAID.
6.
Follow the steps in the succeeding chapters to configure the NAS system.
